Quantron no-devel mode, serial output
Posted by Anonymous on Tue 23rd Apr 2019 13:42
raw | new post
view followups (newest first): Quantron no-devel mode, serial output by Anonymous

Board: Eckelmann AG ECU01
__IMX25_EAG_ECU01_MOTOR_BRIDGE__
mdio_bus: miibus0: probed
nand: ONFI flash detected
nand: NAND device: Manufacturer ID: 0x2c, Chip ID: 0xb1 (Micron MT29F1G16ABBEAH4), 128MiB, page size: 2048, OOB size: 64
Bad block table found at page 65472, version 0x01
Bad block table found at page 65408, version 0x01
imx-usb 53ff4400.usb: USB EHCI 1.00
imxfb imxfb: i.MX Framebuffer driver
malloc space: 0x83efdf80 -> 0x87dfbeff (size 63 MiB)
running /env/bin/init...
Check if Memory is flashbased ...
__PASS__
USB: scanning bus for devices...
Bus 001 Device 001: ID 0000:0000 EHCI Host Controller
1 USB Device(s) found
USB: scanning bus for devices...
1 USB Device(s) found
running automount command 'usb && if [ -e /dev/disk0.0 ]; then mount /dev/disk0.0 /mnt/usbstorage; elif [ -e /dev/disk0 ]; then mount /dev/disk0 /mnt/usbstorage; fi' failed
USB: scanning bus for devices...
1 USB Device(s) found
running automount command 'usb && if [ -e /dev/disk0.0 ]; then mount /dev/disk0.0 /mnt/usbstorage; elif [ -e /dev/disk0 ]; then mount /dev/disk0 /mnt/usbstorage; fi' failed
USB: scanning bus for devices...
1 USB Device(s) found
running automount command 'usb && if [ -e /dev/disk0.0 ]; then mount /dev/disk0.0 /mnt/usbstorage; elif [ -e /dev/disk0 ]; then mount /dev/disk0 /mnt/usbstorage; fi' failed

Hit <CTRL-C> to stop autoboot:  1
#
# developer mode __DISABLED__
#