Board: Eckelmann AG ECU01 __IMX25_EAG_ECU01_MOTOR_BRIDGE__ mdio_bus: miibus0: probed nand: ONFI flash detected nand: NAND device: Manufacturer ID: 0x2c, Chip ID: 0xb1 (Micron MT29F1G16ABBEAH4), 128MiB, page size: 2048, OOB size: 64 Bad block table found at page 65472, version 0x01 Bad block table found at page 65408, version 0x01 imx-usb 53ff4400.usb: USB EHCI 1.00 imxfb imxfb: i.MX Framebuffer driver malloc space: 0x83efdf80 -> 0x87dfbeff (size 63 MiB) running /env/bin/init... Check if Memory is flashbased ... __PASS__ USB: scanning bus for devices... Bus 001 Device 001: ID 0000:0000 EHCI Host Controller 1 USB Device(s) found USB: scanning bus for devices... 1 USB Device(s) found running automount command 'usb && if [ -e /dev/disk0.0 ]; then mount /dev/disk0.0 /mnt/usbstorage; elif [ -e /dev/disk0 ]; then mount /dev/disk0 /mnt/usbstorage; fi' failed USB: scanning bus for devices... 1 USB Device(s) found running automount command 'usb && if [ -e /dev/disk0.0 ]; then mount /dev/disk0.0 /mnt/usbstorage; elif [ -e /dev/disk0 ]; then mount /dev/disk0 /mnt/usbstorage; fi' failed USB: scanning bus for devices... 1 USB Device(s) found running automount command 'usb && if [ -e /dev/disk0.0 ]; then mount /dev/disk0.0 /mnt/usbstorage; elif [ -e /dev/disk0 ]; then mount /dev/disk0 /mnt/usbstorage; fi' failed Hit to stop autoboot: 1 # # developer mode __DISABLED__ #